High performance epoxy/ MWCNTs nanocomposite sensors for multi-purpose sensing in structural health monitoring
DOI:
https://doi.org/10.21935/tls.v3i1.124Abstract
Structural health monitoring (SHM) is necessary for modern technical development. It can be achieved by detecting different quantities such as pressure and strain using highly sensitive and stable sensors. In this work, epoxy/multiwalled carbon nanotubes (MWCNTs) is used as sensing material to detect both strain and pressure. To ensure better performance, dispersion fabrication process was firstly optimized via electrical and microscopic measurements. Then, the piezoresistive performance such as the sensitivity, linearity, stability and drift were investigated under pressure and strain for films prepared with different carbon nanotubes (CNTs) concentration and thickness to define the optimal conditions for each sensing target.
The piezoresistive measurement shows good sensitivity to strain at very low CNTs concentration 0.3 wt. % with a gauge factor (GF = 11.094); which is around 6 times higher than conventional strain sensor, proving the efficiency of the optimized fabrication process parameters that ensure a homogenous distribution. Furthermore, the sensing layer shows also the ability to sustain high pressure load. The sensitivity is found to be highly dependent on the film thickness with higher sensitivity for thicker films in case of pressure sensing in addition to the good sensitivity at very low-pressure range. All these results prove the efficiency of Epoxy/MWCNTs as multi-purpose sensor material.
Downloads
Published
Issue
Section
License
Copyright (c) 2022 Ayda Bouhamed, Xin Sun, Olfa Kanoun

This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with Technologies for Lightweight Structures (TLS) agree to the following terms:
-
The corresponding authors confirm with their imprimatur that the article’s publication in Technologies for Lightweight Structures and the copyright terms have been approved by all the other coauthors.
-
Authors retain copyright and grant Technologies for Lightweight Structures the right of first publication.
-
If the paper is accepted for publication the content is licenced under a Creative Commons Licence “Attribution 4.0 International (CC BY 4.0)”. This permits use, distribution, and reproduction in any medium, provided the original work is properly cited, and is otherwise in compliance with the licence. Alternative Creative Commons Licences may be assigned in duly justified cases after consultation with the publisher (mail to: tls-journal@tu-chemnitz.de).
-
Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., publish it in a book), with an acknowledgement of its initial publication in Technologies for Lightweight Structures.
-
Authors are permitted and encouraged to post the peer-reviewed, pre-copyedited version (post-print) of their articles online (e.g., in institutional repositories or on their website) prior to and during the submission process as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access). If authors wish to republish an article, they are kindly asked to include the following acknowledgment as well as a link to the original source of publication in Technologies for Lightweight Structures to secure consistent citations:
This is a peer-reviewed, pre-copyedited version of an article accepted for publication in the open access journal Technologies for Lightweight Structures (TLS). The original publication with full bibliographic citation is available online at: xxx [insert DOI received upon publication].
For further questions, feel free to contact us via e-mail.