Impregnability and Performance of rCF-nonwovens with epoxy resin
DOI:
https://doi.org/10.21935/tls.v1i2.93Abstract
Currently, the carbon fiber key market increases intensely. In consequence of production, 10–30 % of cost-intensive carbon fiber waste is accumulated by blending fabrics, prepregs which are out of specification and end-of-life products. Because of a landfill ban for carbon fibers, environmental aspects and a cost reduction potential, there is a stronger focus on carbon fiber recycling. Through new recycling methods, the carbon fiber is regained from polymer matrix, but looses its woven structure.
One possibility to re-use chopped recycled fibers is through a fiber mat. Carbon fiber nonwovens can be fabricated by a wet-laid process, for example. For recycled fibers without a specific fiber length and sizing, a challenge lies in separating them in dispersion to get homogenous nonwovens and interlink the fibers in the nonwoven. For the first step, stirring and surfactants improve the separation, hydroxyethylcellulose ensures the bonding. Then the nonwoven can be impregnated with thermosets by resin transfer molding (RTM). The University of Applied Science Niederrhein is the first to investigate the whole process chain from handling recycled carbon fibers in order to attain the finished composite. Optical impregnability is inspected and material properties (tensile strength and Young’s modulus) are analyzed and compared to virgin fibers to get information on performance. A density range from 1.18 (5% CF) to 1.4 g/cm³ (40% CF) is very attractive for lightweight constructions as well.Downloads
Published
Issue
Section
License
Authors who publish with Technologies for Lightweight Structures (TLS) agree to the following terms:
-
The corresponding authors confirm with their imprimatur that the article’s publication in Technologies for Lightweight Structures and the copyright terms have been approved by all the other coauthors.
-
Authors retain copyright and grant Technologies for Lightweight Structures the right of first publication.
-
If the paper is accepted for publication the content is licenced under a Creative Commons Licence “Attribution 4.0 International (CC BY 4.0)”. This permits use, distribution, and reproduction in any medium, provided the original work is properly cited, and is otherwise in compliance with the licence. Alternative Creative Commons Licences may be assigned in duly justified cases after consultation with the publisher (mail to: tls-journal@tu-chemnitz.de).
-
Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., publish it in a book), with an acknowledgement of its initial publication in Technologies for Lightweight Structures.
-
Authors are permitted and encouraged to post the peer-reviewed, pre-copyedited version (post-print) of their articles online (e.g., in institutional repositories or on their website) prior to and during the submission process as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access). If authors wish to republish an article, they are kindly asked to include the following acknowledgment as well as a link to the original source of publication in Technologies for Lightweight Structures to secure consistent citations:
This is a peer-reviewed, pre-copyedited version of an article accepted for publication in the open access journal Technologies for Lightweight Structures (TLS). The original publication with full bibliographic citation is available online at: xxx [insert DOI received upon publication].
For further questions, feel free to contact us via e-mail.
