Advanced joining technology for the production of highly stressable lightweight structures, with fiber-reinforced plastics and metal
DOI:
https://doi.org/10.21935/tls.v1i2.76Abstract
Organic sheets made of fiber-reinforced thermoplastics can make a crucial contribution to increase the lightweight potential of a technical design. They show high specific strength- and stiffness properties as well as good damping characteristics, while being able to show a higher energy absorption capacity than comparable metal constructions. In addition, organic sheets provide good recycling capabilities. Nowadays, multi-material designs are an established way in the automotive industry to combine the benefits of metal and fiber-reinforced plastics (FRP). Currently used technologies for the joining of organic sheets and metals in large-scale production are mechanical joining and adhesive technologies. Both require large overlapping areas to achieve the desired joint strength and stiffness of the technical design. Additionally, mechanical joining is usually combined with “fiber-destroying” pre-drilling and punching processes. This will disturb the force flux at the joint zone by causing unwanted fiber- and inter-fiber failure and inducing critical notch stresses. Therefore, the multi-material design with fiber-reinforced thermoplastics and metals needs optimized joining techniques that don’t interrupt the force flux, so that higher loads can be induced and the full benefit of the FRP material can be used. This article focuses on the characterization of a new joining technology, based on the Cold Metal Transfer (CMT) welding process, that allows to join organic sheets and metals in a load path optimized design. This is achieved by realigning the fibers around the joint zone by the integration of a thin metal pin. The alignment of the fibers will be similar to load paths of fibers inside structures found in nature. A tree with a knothole is always going to align its fibers in principle stress direction. As a result of the bionic fiber design, high joining strengths can be achieved. The increase of the joint strength compared to blind riveting was performed and proven with stainless steel and orthotropic reinforced composites in tensile shear-tests, based on the DIN EN ISO 14273.
Downloads
Published
Issue
Section
License
Authors who publish with Technologies for Lightweight Structures (TLS) agree to the following terms:
-
The corresponding authors confirm with their imprimatur that the article’s publication in Technologies for Lightweight Structures and the copyright terms have been approved by all the other coauthors.
-
Authors retain copyright and grant Technologies for Lightweight Structures the right of first publication.
-
If the paper is accepted for publication the content is licenced under a Creative Commons Licence “Attribution 4.0 International (CC BY 4.0)”. This permits use, distribution, and reproduction in any medium, provided the original work is properly cited, and is otherwise in compliance with the licence. Alternative Creative Commons Licences may be assigned in duly justified cases after consultation with the publisher (mail to: tls-journal@tu-chemnitz.de).
-
Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., publish it in a book), with an acknowledgement of its initial publication in Technologies for Lightweight Structures.
-
Authors are permitted and encouraged to post the peer-reviewed, pre-copyedited version (post-print) of their articles online (e.g., in institutional repositories or on their website) prior to and during the submission process as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access). If authors wish to republish an article, they are kindly asked to include the following acknowledgment as well as a link to the original source of publication in Technologies for Lightweight Structures to secure consistent citations:
This is a peer-reviewed, pre-copyedited version of an article accepted for publication in the open access journal Technologies for Lightweight Structures (TLS). The original publication with full bibliographic citation is available online at: xxx [insert DOI received upon publication].
For further questions, feel free to contact us via e-mail.
